HELP NEEDED

A forum for the discussion of anything that doesn't fit into the other categories. Just remember to keep it friendly

HELP NEEDED

Postby bob dewater » Thu Oct 31, 2013 4:15 pm

I have a 71 Oliver 1655, R&R rings and rod bearings, i noticed the crank doent not have oil delivery ports for the rod bearings, how does the rods get oil and how does the pistons/rings receive oil, I have stopped working on it until i have a better understanding of this for fear of damage.....
any educated help appreciated !!
Thanx
Bob
bob dewater
 
Posts: 1
Joined: Thu Oct 31, 2013 4:08 pm

Postby H. Deckler » Fri Nov 01, 2013 8:17 am

Rods receive lube spray from oil gallery in the block, splash from that takes care of pistons and wrist pins. Note oil hole on one side of connecting rod and matching one in bearing shell, rods must be properly oriented during installation. Do you have shop manual? It can be ordered fromhttp://www.floydcountymuseum.org/, may save you a lot of grief. mains and front camshaft bearing are pressure lubed. Shop manual will have lube diagram as well as other needed info on rebuild.
H. Deckler
 
Posts: 51
Joined: Thu Apr 08, 2004 10:40 am


Return to Miscellaneous Forum

Who is online

Users browsing this forum: No registered users and 2 guests

cron